3M™ Secondary Liner 7526L, Tan, 4.2 mil, Roll, Config
-
Return Policy
Our site states no returns allowed; however, in addition to a few exceptions, if your order is defective or damaged, the order will be replaced with good product.
-
IndustryIB
-
Lead Time35
-
Manufacturer3M
-
SAP7100072921
-
3M ID70000093875
-
Product Formal Name3M™ Secondary Liner 7526L, Tan, 4.2 mil, Roll, Config
-
Case UnitCase of 1
-
Unit of MeasureRoll
-
Estimated Lead Time35
-
SizeConfigurable
-
Inventory Status CodeConfigurable
-
Technical Informationhttps://multimedia.3m.com/mws/media/199845O/secondary-liners-7526l-and-7527l.pdf&fn=7526L_7527L_10699.pdf
-
Country of OriginUSA
-
Return PolicyNo Return
-
WidthConfigurable
-
LengthConfigurable
- Bullets
-
Bullet 1- For use with screen printable adhesives
- 4.2 mil 58# polycoated kraft provides moisture stability, resists wrinkling and curling
- Designed with a silicone release coating on two sides
- Gloss side (inside of roll) provides medium release level
- Matte side (outside of roll) provides low release level
-
- Transportation
-
ECCN NumberEAR99
-
UNSPSC Code31201500
-
United States Department Of Transportation Ground US DOT, 49 CFRNOT REGULATED
-
United States Department Of Transportation Vessel US DOT, 49 CFRNOT REGULATED
-
NMFC Item150930
-
NMFC Class060.0
-
NMFC Sub02
-
Transport Protective ServicePROTECTIVE SERVICE NOT REQUIRED
-
International Air Transport AssociationNOT REGULATED
-
International Maritime OrganizationNOT REGULATED
-
Flashpoint TransportNo Flash Point
-
-
SKU7100072921
Our site states no returns allowed; however, if your order is defective or damaged, the order will be replaced with good product. In addition, we will attempt to return all your product (not only damaged product) if 3M grants the return based on various factors. Some items may be approved for return pending approval from 3M. Some but not all factors include if the item is a 3M stock item and elapsed time from receipt of product to issued return request. Note: 3M will not accept a return if the item is made to order or if the order is less than $600.00. Please double check accuracy of your orders prior to placing them. Details regarding if an item is stock or made to order can be found in the specifications tab of the item page. N = Made to order Item. S = Stock Item. We cannot guarantee any returns.
If you received a defective or damaged shipment, please email us at support@industrialgeneralstore.com explaining in detail the reason for requesting a replacement so we can contact 3M and initiate the return and new shipment.