Scotch-Brite™ Metal Blending Roll, MB-RL, SiC Medium, Config
-
Return Policy
Our site states no returns allowed; however, in addition to a few exceptions, if your order is defective or damaged, the order will be replaced with good product.
-
IndustryIB
-
Lead Time17
-
Manufacturer3M
-
SAP7100051821
-
3M ID61000050486
-
Product Formal NameScotch-Brite™ Metal Blending Roll, MB-RL, SiC Medium, Config
-
BrandScotch-Brite
-
Case UnitCase of 1
-
Unit of MeasureRoll
-
Estimated Lead Time17
-
Grit/MicronMedium
-
SizeConfigurable
-
Inventory Status CodeConfigurable
-
Instructions/Manualhttps://multimedia.3m.com/mws/mediawebserver?mwsId=SSSSSuUn_zu8l00xMx_SPx2xPv70k17zHvu9lxtD7SSSSSS--
-
Country of OriginUSA
-
Product FormRoll
-
Return PolicyNo Return
-
WidthConfigurable
-
LengthConfigurable
- Bullets
-
Bullet 1- Great flexibility and conformability for weld burn removal, blending and satin finishing while leaving a consistent Finish
- nylon web won’t melt on hot welds, allowing blending without waiting
- silicon carbide mineral in medium grade coarseness Works efficiently on weld burns and cleaning stainless steel cooking tops
- Springy fibers conform to irregular surfaces with uniform results
- load resistant open web construction Provides extended Use
- Comes in a variety of widths to fit various tools and can be sized according to the application
-
- Transportation
-
ECCN NumberEAR99
-
UNSPSC Code31190000
-
United States Department Of Transportation Ground US DOT, 49 CFRNOT REGULATED
-
United States Department Of Transportation Vessel US DOT, 49 CFRNOT REGULATED
-
NMFC Item001100
-
NMFC Class055.0
-
NMFC Sub00
-
Transport Protective ServicePROTECTIVE SERVICE NOT REQUIRED
-
International Air Transport AssociationNOT REGULATED
-
International Maritime OrganizationNOT REGULATED
-
Flashpoint TransportNo Flash Point
-
-
SKU7100051821
-
UPC/ISBN00048011644158
Our site states no returns allowed; however, if your order is defective or damaged, the order will be replaced with good product. In addition, we will attempt to return all your product (not only damaged product) if 3M grants the return based on various factors. Some items may be approved for return pending approval from 3M. Some but not all factors include if the item is a 3M stock item and elapsed time from receipt of product to issued return request. Note: 3M will not accept a return if the item is made to order or if the order is less than $600.00. Please double check accuracy of your orders prior to placing them. Details regarding if an item is stock or made to order can be found in the specifications tab of the item page. N = Made to order Item. S = Stock Item. We cannot guarantee any returns.
If you received a defective or damaged shipment, please email us at support@industrialgeneralstore.com explaining in detail the reason for requesting a replacement so we can contact 3M and initiate the return and new shipment.