Standard Abrasives™ Buff and Blend HS Flap Brush 875190, 12 in x 3 in x 5 in FB090 23-11 A MED Hard Density, 5 per case
-
Return Policy
Our site states no returns allowed; however, in addition to a few exceptions, if your order is defective or damaged, the order will be replaced with good product.
-
IndustryIB
-
Lead Time15
-
Manufacturer3M
-
SAP7000047091
-
3M ID66000043514
-
UPC00-51115-36751-9
-
Product Formal NameStandard Abrasives™ Buff and Blend HS Flap Brush 875190, 12 in x 3 in x 5 in FB090 23-11 A MED Hard Density, 5 per case
-
BrandStandard Abrasives
-
Case UnitCase of 1
-
Unit of MeasureEach
-
Estimated Lead Time15
-
Inventory Status CodeN
-
Data Sheethttps://multimedia.3m.com/mws/media/566297O/standard-abrasives-high-strength-buff-and-blend-flyer.pdf&fn=61-5002-8244-9.pdf
-
Instructions/Manualhttps://multimedia.3m.com/mws/mediawebserver?mwsId=SSSSSuUn_zu8l00xMYtxPYtGMv70k17zHvu9lxtD7SSSSSS--
-
Country of OriginUSA
-
Return PolicyNo Return
-
Box Length (in)15.4
-
Box Width (in)15.4
-
Box Height (in)5.6
- Bullets
-
Bullet 1Provides decorative, high luster finishes on stainless steel, brass and aluminum;Tough nylon face removes surface contaminants without leaving lines or gouging the work piece;High strength durability is tear-resistant and stands up to irregular shaped parts;Open web design resists loading and eliminates metal contamination of workpiece;Resin coated surface runs cool and is waterproof for use with lubricants;Various sizes available for wide range of tools: straight shaft portable grinder, bench motor, backstand, floor lathe, rotary, straight line, and robotic
-
- Transportation
-
ECCN NumberEAR99
-
Harmonized Tariff Schedule Number6805301000
-
United States Department Of Transportation Ground US DOT, 49 CFRNOT REGULATED
-
United States Department Of Transportation Vessel US DOT, 49 CFRNOT REGULATED
-
NMFC Item033100
-
NMFC Class200.0
-
NMFC Sub01
-
Transport Protective ServicePROTECTIVE SERVICE NOT REQUIRED
-
International Air Transport AssociationNOT REGULATED
-
International Maritime OrganizationNOT REGULATED
-
Flashpoint TransportNo Flash Point
-
Our site states no returns allowed; however, if your order is defective or damaged, the order will be replaced with good product. In addition, we will attempt to return all your product (not only damaged product) if 3M grants the return based on various factors. Some items may be approved for return pending approval from 3M. Some but not all factors include if the item is a 3M stock item and elapsed time from receipt of product to issued return request. Note: 3M will not accept a return if the item is made to order or if the order is less than $600.00. Please double check accuracy of your orders prior to placing them. Details regarding if an item is stock or made to order can be found in the specifications tab of the item page. N = Made to order Item. S = Stock Item. We cannot guarantee any returns.
If you received a defective or damaged shipment, please email us at support@industrialgeneralstore.com explaining in detail the reason for requesting a replacement so we can contact 3M and initiate the return and new shipment.