3M™ Performance Spray Gun Needle, 26838, 1 per case
Controls fluid flow as the trigger of the HVLP spray gun is pulled;Durable stainless steel construction resists wear, bending and damage;Engineered to provide a leakproof seal when used with 3M™ Performance Spray Gun atomizing heads;Specifically designed replacement part for 3M™ Performance Spray Gun
-
Return Policy
Our site states no returns allowed; however, in addition to a few exceptions, if your order is defective or damaged, the order will be replaced with good product.
-
IndustryIB
-
Lead Time2
-
Manufacturer3M
-
SAP7100220927
-
3M ID60455108757
-
UPC00051131268388
-
Product Formal Name3M™ Performance Spray Gun Needle, 26838, 1 per case
-
Case UnitCase of 1
-
Unit of MeasureEach
-
Estimated Lead Time2
-
Inventory Status CodeS
-
Country of OriginUSA
-
Return PolicyNo Return
-
Box Length (in)6.6
-
Box Width (in)5.4
-
Box Height (in)5
- Bullets
-
Bullet 1- Specifically designed replacement part for 3M™ Performance Spray Gun
- Durable stainless steel construction resists wear, bending and damage
- Engineered to provide a leakproof seal when used with 3M™ Performance Spray Gun atomizing heads
- Controls fluid flow as the trigger of the HVLP spray gun is pulled
-
-
SKU7100220927
-
UPC/ISBN00051131268388
The 3M™ Performance Spray Gun Needle is designed as a replacement part for the 3M™ Performance Spray Gun. Rigid non-reactive stainless steel construction is easy to clean and resists bending. It attaches to the spray gun's trigger and flow control knob to give the painter precise control of the spray gun's flow rate and atomization.Efficiently stops fluid flow when the spray gun trigger is released. This replacement-part needle gives the spray gun a performance tune-up without the effort of a full spray gun rebuild. Replace the needle when it becomes bent, damaged, or if the spray gun begins to leak through the atomizing head's tip.Use with the 3M™ Performance Spray Gun, an innovative solution designed with the industrial painter in mind. Made from an impact-resistant composite, it is one of the lightest spray guns in the industry, yet durable enough for demanding industrial conditions. Its versatile design allows painters to spray from a pressurized source or a gravity cup, and replaceable atomizing heads allow you to spray a wide range of coatings while delivering like-new performance with every new nozzle.
Our site states no returns allowed; however, if your order is defective or damaged, the order will be replaced with good product. In addition, we will attempt to return all your product (not only damaged product) if 3M grants the return based on various factors. Some items may be approved for return pending approval from 3M. Some but not all factors include if the item is a 3M stock item and elapsed time from receipt of product to issued return request. Note: 3M will not accept a return if the item is made to order or if the order is less than $600.00. Please double check accuracy of your orders prior to placing them. Details regarding if an item is stock or made to order can be found in the specifications tab of the item page. N = Made to order Item. S = Stock Item. We cannot guarantee any returns.
If you received a defective or damaged shipment, please email us at support@industrialgeneralstore.com explaining in detail the reason for requesting a replacement so we can contact 3M and initiate the return and new shipment.