3M™ PPS™ Series 2.0 Type H/O Pressure Cup, 26124, LG/STND, 2 per case
-
Return Policy
Our site states no returns allowed; however, in addition to a few exceptions, if your order is defective or damaged, the order will be replaced with good product.
-
Lead Time2
-
Manufacturer3M
-
SAP7100191753
-
UPC00-51131-26124-2
-
Product Formal Name3M™ PPS™ Series 2.0 Type H/O Pressure Cup, 26124, LG/STND, 2 per case
-
BrandPPS
-
Case UnitCase of 2
-
Unit of MeasureKit(s)
-
Part Number26124
-
Estimated Lead Time2
-
Inventory Status CodeS
-
Country of OriginUSA
-
Return PolicyNo Return
-
Box Length (in)10.8
-
Box Width (in)5.6
-
Box Height (in)8.6
- Bullets
-
Bullet 1- Pressurized hard cups and collars use with 3M™ PPS™ Series 2.0 spray system
- Designed to efficiently spray thick, high viscosity liquids
- 3M™ PPS™ is an all-in-one disposable solution for measuring, mixing, filtering, and spraying of paint materials
- System enables the painter to consistently spray at 90° to the part, no matter the part orientation (even upside down)
- The all-in-one solution reduces the chance of outside contamination and reduces paint consumption
- PPS™ reduces cleaning solvent consumption up to 70% and reduces prep and clean-up time by 50%
- System delivers improved quality, lower material cost, less solvent consumption, improved productivity, less mess and easier use
-
- Transportation
-
United States Department Of Transportation Ground US DOT, 49 CFRNOT REGULATED
-
United States Department Of Transportation Vessel US DOT, 49 CFRNOT REGULATED
-
NMFC Item156600
-
NMFC Class175.0
-
NMFC Sub04
-
Transport Protective ServicePROTECTIVE SERVICE NOT REQUIRED
-
International Air Transport AssociationNOT REGULATED
-
International Maritime OrganizationNOT REGULATED
-
Flashpoint TransportNo Flash Point
-
-
SKU7100191753
-
UPC/ISBN00051131261242
Our site states no returns allowed; however, if your order is defective or damaged, the order will be replaced with good product. In addition, we will attempt to return all your product (not only damaged product) if 3M grants the return based on various factors. Some items may be approved for return pending approval from 3M. Some but not all factors include if the item is a 3M stock item and elapsed time from receipt of product to issued return request. Note: 3M will not accept a return if the item is made to order or if the order is less than $600.00. Please double check accuracy of your orders prior to placing them. Details regarding if an item is stock or made to order can be found in the specifications tab of the item page. N = Made to order Item. S = Stock Item. We cannot guarantee any returns.
If you received a defective or damaged shipment, please email us at support@industrialgeneralstore.com explaining in detail the reason for requesting a replacement so we can contact 3M and initiate the return and new shipment.
