Bondo® Double Handle Locking Suction Cup Dent Puller, 00956, 2 per case
-
Return Policy
Our site states no returns allowed; however, in addition to a few exceptions, if your order is defective or damaged, the order will be replaced with good product.
-
IndustryIB
-
Lead Time2
-
Manufacturer3M
-
SAP7100151310
-
3M ID60455091730
-
UPC00076308009564
-
Product Formal NameBondo® Double Handle Locking Suction Cup Dent Puller, 00956, 2 per case
-
BrandBondo
-
Case UnitCase of 2
-
Unit of MeasureEach
-
Estimated Lead Time2
-
Country of OriginChina
-
Return PolicyNo Return
-
Box Length (in)8.3
-
Box Width (in)6.4
-
Box Height (in)8.5
- Bullets
-
Bullet 1- Attach to and pull out dents in car and truck panels in minutes
- Double handle design makes locking and pulling simple and effective
- Double handle locking action creates 300 times more suction versus a non-locking suction cup dent puller
- Compact, lightweight size saves space and makes the tool easy to store and carry
- Much less expensive and time consuming alternative to full body work
- Small, lightweight tool has a 4” rubber suction cup that attaches firmly to your vehicle
- Simple, practical and economical.
- Dents pop out in seconds
- Easy to Use
- Use during the PREPARE stage of the 3M™ Body Repair System
-
- Transportation
-
ECCN NumberEAR99
-
Harmonized Tariff Schedule Number4016996050
-
UNSPSC Code25000000
-
United States Department Of Transportation Ground US DOT, 49 CFRNOT REGULATED
-
United States Department Of Transportation Vessel US DOT, 49 CFRNOT REGULATED
-
NMFC Item186620
-
NMFC Class092.5
-
NMFC Sub07
-
Transport Protective ServicePROTECTIVE SERVICE NOT REQUIRED
-
International Air Transport AssociationNOT REGULATED
-
International Maritime OrganizationNOT REGULATED
-
Flashpoint TransportNo Flash Point
-
-
SKU7100151310
Our site states no returns allowed; however, if your order is defective or damaged, the order will be replaced with good product. In addition, we will attempt to return all your product (not only damaged product) if 3M grants the return based on various factors. Some items may be approved for return pending approval from 3M. Some but not all factors include if the item is a 3M stock item and elapsed time from receipt of product to issued return request. Note: 3M will not accept a return if the item is made to order or if the order is less than $600.00. Please double check accuracy of your orders prior to placing them. Details regarding if an item is stock or made to order can be found in the specifications tab of the item page. N = Made to order Item. S = Stock Item. We cannot guarantee any returns.
If you received a defective or damaged shipment, please email us at support@industrialgeneralstore.com explaining in detail the reason for requesting a replacement so we can contact 3M and initiate the return and new shipment.