Versatile Adhesion Promoter for LSE PlasticsFormulated specifically for use with 3M™ Acrylic Foam Tapes, our 3M™ Adhesion Promoter 4298 promotes a permanent bond with a wide range of low surface energy plastics and other materials commonly used in automotive OEM. It works well with PPO, polypropylene (PP) as well as polycarbonate (PC) and PC + ABS. It dries in 30 to 90 seconds for fast and efficient application. Once it's dry, it's ready to accept attachment tape. The adhesion promoter can also be cleaned from most surfaces using acetone solvent. The 3M™ Adhesion Promoter 4298 is specifically formulated to be used with 3M™ Acrylic Foam Tapes and 3M™ Acrylic Plus Tapes.Easy to Apply and Use3M™ Adhesion Promoter 4298 is supplied in an easy-to-use sponge applicator packet. This packet tears open easily across the top to expose the sponge applicator, and the bottom section of the packet is excellent for no-mess application. The adhesion promoter can also be applied using a gravity feed wipe, knurled roller, sprayer, or a felt-tipped or similar applicator. 3M™ Adhesion Promoter 4298 can be cleaned up with methylethyl ketone (MEK) or acetone solvents (be careful with solvents on plastics).Recommended Applications‎ LSE plastic trim and partsAutomotive dash and interior trimInjection-molded side body side moldingsAutomotive claddingsFor use with 3M™ Acrylic Foam Tapes and 3M™ Acrylic Plus TapesBetter Science for Better Adhesion from 3MSince 1925 when one of our lab assistants invented masking tape, 3M has been applying science to life -developing adhesive products and technologies that help entire industries and individual businesses worldwide. The work that began with a single 3M engineer now spans decades and generations - and all of it goes into each of our products for automotive OEMs and Tier Suppliers, like 3M™ Adhesion Promoter 4298.