Standard Abrasives™ A/O Buff and Blend EP Roll 830105, 4-1/2 in x 30 ft A VFN, 2 per case
-
Return Policy
Our site states no returns allowed; however, in addition to a few exceptions, if your order is defective or damaged, the order will be replaced with good product.
-
IndustryIB
-
Lead Time13
-
Manufacturer3M
-
SAP7000047084
-
3M ID66000034836
-
UPC00-51115-35883-8
-
Product Formal NameStandard Abrasives™ A/O Buff and Blend EP Roll 830105, 4-1/2 in x 30 ft A VFN, 2 per case
-
BrandStandard Abrasives
-
Case UnitCase of 2
-
Unit of MeasureRoll
-
Estimated Lead Time13
-
Grit/MicronVery Fine
-
Size4-1/2 in x 30 ft
-
Inventory Status CodeN
-
Data Sheethttps://multimedia.3m.com/mws/media/563940O/standard-abrasives-quick-change-discs-for-disc-sanders.pdf&fn=61-5002-8236-5_2014_R1.pdf
-
Instructions/Manualhttps://multimedia.3m.com/mws/mediawebserver?mwsId=SSSSSuUn_zu8l00xMYtx48tBPv70k17zHvu9lxtD7SSSSSS--
-
Country of OriginUSA
-
Return PolicyNo Return
-
Width4-1/2 in
-
Length30 ft
-
Box Length (in)12.9
-
Box Width (in)12.4
-
Box Height (in)12.4
- Bullets
-
Bullet 1- low cost for converting into other forms
- open web is load resistant, reducing the likelihood of Abrasive clogging with debris, thereby prolonging service life
- aluminum oxide mineral is friable and breaks down to reveal sharp cutting edges for a consistent cut
- Abrasive May be run wet to help wash away swarf and keep Abrasive running cool, minimizing potential for heat-induced smearing and blemishes
- roll form May be shaped according to application requirements
-
- Transportation
-
ECCN NumberEAR99
-
Harmonized Tariff Schedule Number6805301000
-
UNSPSC Code31191500
-
United States Department Of Transportation Ground US DOT, 49 CFRNOT REGULATED
-
United States Department Of Transportation Vessel US DOT, 49 CFRNOT REGULATED
-
NMFC Item001100
-
NMFC Class055.0
-
NMFC Sub00
-
Transport Protective ServicePROTECTIVE SERVICE NOT REQUIRED
-
International Air Transport AssociationNOT REGULATED
-
International Maritime OrganizationNOT REGULATED
-
Flashpoint TransportNo Flash Point
-
Our site states no returns allowed; however, if your order is defective or damaged, the order will be replaced with good product. In addition, we will attempt to return all your product (not only damaged product) if 3M grants the return based on various factors. Some items may be approved for return pending approval from 3M. Some but not all factors include if the item is a 3M stock item and elapsed time from receipt of product to issued return request. Note: 3M will not accept a return if the item is made to order or if the order is less than $600.00. Please double check accuracy of your orders prior to placing them. Details regarding if an item is stock or made to order can be found in the specifications tab of the item page. N = Made to order Item. S = Stock Item. We cannot guarantee any returns.
If you received a defective or damaged shipment, please email us at support@industrialgeneralstore.com explaining in detail the reason for requesting a replacement so we can contact 3M and initiate the return and new shipment.