Scotch-Brite™ SL Surface Conditioning Belt, A/O Coarse, 1/2 in x 18 in
-
Return Policy
Our site states no returns allowed; however, in addition to a few exceptions, if your order is defective or damaged, the order will be replaced with good product.
-
IndustryIB
-
Lead Time7
-
Manufacturer3M
-
SAP7100215987
-
3M IDUU010830840
-
UPC00638060566787
-
Product Formal NameScotch-Brite™ SL Surface Conditioning Belt, A/O Coarse, 1/2 in x 18 in
-
BrandScotch-Brite
-
Case UnitCase of 20
-
Unit of MeasureEach
-
Product IDSL-BS
-
Estimated Lead Time7
-
GradeCoarse
-
Grit/MicronCoarse
-
Size1/2 in x 18 in
-
Inventory Status CodeN
-
Country of OriginUSA
-
Product FormBelt
-
Return PolicyNo Return
-
Width1/2 in
-
Length18 in
- Bullets
-
Bullet 1Aluminum Oxide mineral, available in a range of grades, cuts sharp and leaves a fine finish, For use on backstand and off hand equipment, Reinforced backing and non-woven open web material provides superior flexibility for detail work, over contours and edges, Reduced loading and heat build-up allow extended operating time and consistent surface conditioning results, Aggressive cutting without gouging, removes surface imperfections, grindlines, mill and other marks
-
- Transportation
-
ECCN NumberEAR99
-
Our site states no returns allowed; however, if your order is defective or damaged, the order will be replaced with good product. In addition, we will attempt to return all your product (not only damaged product) if 3M grants the return based on various factors. Some items may be approved for return pending approval from 3M. Some but not all factors include if the item is a 3M stock item and elapsed time from receipt of product to issued return request. Note: 3M will not accept a return if the item is made to order or if the order is less than $600.00. Please double check accuracy of your orders prior to placing them. Details regarding if an item is stock or made to order can be found in the specifications tab of the item page. N = Made to order Item. S = Stock Item. We cannot guarantee any returns.
If you received a defective or damaged shipment, please email us at support@industrialgeneralstore.com explaining in detail the reason for requesting a replacement so we can contact 3M and initiate the return and new shipment.