Scotch-Brite™ Multi-Finishing Wheel, MU-WL, 4S Coarse, 6 in x MISC x 1 in, Config
-
Return Policy
Our site states no returns allowed; however, in addition to a few exceptions, if your order is defective or damaged, the order will be replaced with good product.
-
IndustryIB
-
Lead Time10
-
Manufacturer3M
-
SAP7100130928
-
3M ID61000504342
-
Product Formal NameScotch-Brite™ Multi-Finishing Wheel, MU-WL, 4S Coarse, 6 in x MISC x 1
in, Config -
BrandScotch-Brite
-
Case UnitCase of 1
-
Unit of MeasureEach
-
Product IDMU-WL
-
Estimated Lead Time10
-
GradeCoarse
-
Grit/MicronCoarse
-
Size6 in x MISC x 1 in
-
ColorBlack
-
Inventory Status CodeConfigurable
-
Country of OriginUSA
-
Product FormWheel
-
Return PolicyNo Return
-
Width6 in
-
LengthMISC
- Bullets
-
Bullet 1- Provides uniform grain for final finishing on stainless steel, ferrous, and Non-ferrous metals
- highly Conformable for consistent finishing on Contoured, curved and other surfaces
- moderate aggressiveness and lighter density provide controlled WEAR for consistent results over the life of the wheel
- convolute construction Provides a Balanced, smooth running wheel throughout Product life
- open, Non-woven web runs cool and lessens impact on heat-sensitive materials
-
- Transportation
-
ECCN NumberEAR99
-
UNSPSC Code31191600
-
United States Department Of Transportation Ground US DOT, 49 CFRNOT REGULATED
-
United States Department Of Transportation Vessel US DOT, 49 CFRNOT REGULATED
-
NMFC Item001020
-
NMFC Class055.0
-
NMFC Sub00
-
Transport Protective ServicePROTECTIVE SERVICE NOT REQUIRED
-
International Air Transport AssociationNOT REGULATED
-
International Maritime OrganizationNOT REGULATED
-
Flashpoint TransportNo Flash Point
-
-
SKU7100130928
-
UPC/ISBN00076308210472
Our site states no returns allowed; however, if your order is defective or damaged, the order will be replaced with good product. In addition, we will attempt to return all your product (not only damaged product) if 3M grants the return based on various factors. Some items may be approved for return pending approval from 3M. Some but not all factors include if the item is a 3M stock item and elapsed time from receipt of product to issued return request. Note: 3M will not accept a return if the item is made to order or if the order is less than $600.00. Please double check accuracy of your orders prior to placing them. Details regarding if an item is stock or made to order can be found in the specifications tab of the item page. N = Made to order Item. S = Stock Item. We cannot guarantee any returns.
If you received a defective or damaged shipment, please email us at support@industrialgeneralstore.com explaining in detail the reason for requesting a replacement so we can contact 3M and initiate the return and new shipment.