Scotch-Brite™ High Strength Flap Brush, HS-FB, 3A Medium, 10 in x MISC x 5 in, Config
-
Return Policy
Our site states no returns allowed; however, in addition to a few exceptions, if your order is defective or damaged, the order will be replaced with good product.
-
IndustryIB
-
Lead Time28
-
Manufacturer3M
-
SAP7100129737
-
3M ID61000507139
-
Product Formal NameScotch-Brite™ High Strength Flap Brush, HS-FB, 3A Medium, 10 in x MISC x
5 in, Config -
BrandScotch-Brite
-
Case UnitCase of 1
-
Unit of MeasureEach
-
Product IDHS-FB
-
Estimated Lead Time28
-
GradeMedium
-
Grit/MicronMedium
-
Size10 in x MISC x 5 in
-
Inventory Status CodeConfigurable
-
Country of OriginUSA
-
Product FormFlap Brush
-
Return PolicyNo Return
-
Width10 in
-
LengthMISC
- Bullets
-
Bullet 1- aluminum oxide mineral cuts sharp but Leaves a soft scratch pattern, good for cleaning and finishing
- Available in a range of grades, densities and sizes so operators can tailor the brush to meet the needs of their unique application
- especially dense web contributes to Abrasive longevity and durability
- open web is buoyant and Responsive, minimizing alteration of the workpiece
- open web has Gaps between fibers, helping reduce loading and clogging of fibers
-
- Transportation
-
ECCN NumberEAR99
-
UNSPSC Code31191500
-
United States Department Of Transportation Ground US DOT, 49 CFRNOT REGULATED
-
United States Department Of Transportation Vessel US DOT, 49 CFRNOT REGULATED
-
NMFC Item197370
-
NMFC Class077.5
-
NMFC Sub00
-
Transport Protective ServicePROTECTIVE SERVICE NOT REQUIRED
-
International Air Transport AssociationNOT REGULATED
-
International Maritime OrganizationNOT REGULATED
-
Flashpoint TransportNo Flash Point
-
-
SKU7100129737
-
UPC/ISBN00076308213268
Our site states no returns allowed; however, if your order is defective or damaged, the order will be replaced with good product. In addition, we will attempt to return all your product (not only damaged product) if 3M grants the return based on various factors. Some items may be approved for return pending approval from 3M. Some but not all factors include if the item is a 3M stock item and elapsed time from receipt of product to issued return request. Note: 3M will not accept a return if the item is made to order or if the order is less than $600.00. Please double check accuracy of your orders prior to placing them. Details regarding if an item is stock or made to order can be found in the specifications tab of the item page. N = Made to order Item. S = Stock Item. We cannot guarantee any returns.
If you received a defective or damaged shipment, please email us at support@industrialgeneralstore.com explaining in detail the reason for requesting a replacement so we can contact 3M and initiate the return and new shipment.