Scotch-Brite™ EXL Unitized Block, XL-UB, 6S Fine, 3/4 in, Config
-
Return Policy
Our site states no returns allowed; however, in addition to a few exceptions, if your order is defective or damaged, the order will be replaced with good product.
-
IndustryIB
-
Lead Time28
-
Manufacturer3M
-
SAP7100134485
-
3M ID61000513210
-
Product Formal NameScotch-Brite™ EXL Unitized Block, XL-UB, 6S Fine, 3/4 in, Config
-
BrandScotch-Brite
-
Case UnitCase of 1
-
Unit of MeasureEach
-
Product IDXL-UB
-
Estimated Lead Time28
-
GradeFine
-
Grit/MicronFine
-
Size3/4 in
-
Inventory Status CodeConfigurable
-
Instructions/Manualhttps://multimedia.3m.com/mws/mediawebserver?mwsId=SSSSSuUn_zu8l00xM82BOY_vmv70k17zHvu9lxtD7SSSSSS--
-
Country of OriginUSA
-
Product FormBlock
-
Return PolicyNo Return
-
Width3/4 in
- Bullets
-
Bullet 1- EXL material offers Great durability and edge retention for tough burrs and sharp edges
- highly durable block is Suitable for a wide range of deburring and finishing applications
- cut-to-size block May be shaped according to application
- Available in a range of grades, minerals and densities
- nylon fibers break down to expose fresh mineral, leading to more consistent finishes
- Gaps between fibers permit debris to escape, helping with load resistance
-
- Transportation
-
ECCN NumberEAR99
-
UNSPSC Code31191600
-
United States Department Of Transportation Ground US DOT, 49 CFRNOT REGULATED
-
United States Department Of Transportation Vessel US DOT, 49 CFRNOT REGULATED
-
NMFC Item001020
-
NMFC Class055.0
-
NMFC Sub00
-
Transport Protective ServicePROTECTIVE SERVICE NOT REQUIRED
-
International Air Transport AssociationNOT REGULATED
-
International Maritime OrganizationNOT REGULATED
-
Flashpoint TransportNo Flash Point
-
-
SKU7100134485
-
UPC/ISBN00076308219345
Our site states no returns allowed; however, if your order is defective or damaged, the order will be replaced with good product. In addition, we will attempt to return all your product (not only damaged product) if 3M grants the return based on various factors. Some items may be approved for return pending approval from 3M. Some but not all factors include if the item is a 3M stock item and elapsed time from receipt of product to issued return request. Note: 3M will not accept a return if the item is made to order or if the order is less than $600.00. Please double check accuracy of your orders prior to placing them. Details regarding if an item is stock or made to order can be found in the specifications tab of the item page. N = Made to order Item. S = Stock Item. We cannot guarantee any returns.
If you received a defective or damaged shipment, please email us at support@industrialgeneralstore.com explaining in detail the reason for requesting a replacement so we can contact 3M and initiate the return and new shipment.