3M™ Thin Flexographic Mounting Tape 2205, Translucent, 5 mil, Roll, Config
-
Return Policy
Our site states no returns allowed; however, in addition to a few exceptions, if your order is defective or damaged, the order will be replaced with good product.
-
IndustryIB
-
Lead Time7
-
Manufacturer3M
-
SAP7100133123
-
3M ID70006777349
-
Product Formal Name3M™ Thin Flexographic Mounting Tape 2205, Translucent, 5 mil, Roll,
Config -
Case UnitCase of 1
-
Unit of MeasureRoll
-
Estimated Lead Time7
-
SizeConfigurable
-
Inventory Status CodeConfigurable
-
Country of OriginUSA
-
Return PolicyNo Return
-
WidthConfigurable
-
LengthConfigurable
- Bullets
-
Bullet 10.005 inch (0.13 mm) double-coated tape designed for the corrugated printing business to hold flexographic print plates to PVC carriers/saddles and PET carriers/saddles, Linered side of the tape has crosshatched pattern that allows air to escape from between the tape and the carrier, Adhesive on non-linered side of the tape is designed for mounting of photopolymer plates, Excellent holding power on-press with high plate side adhesion, Embossed polycoated kraft (PCK) paper liner, Clean plate removal when demounting or repositioning
-
- Transportation
-
ECCN NumberEAR99
-
United States Department Of Transportation Ground US DOT, 49 CFRNOT REGULATED
-
United States Department Of Transportation Vessel US DOT, 49 CFRNOT REGULATED
-
NMFC Item157190
-
NMFC Class060.0
-
NMFC Sub00
-
Transport Protective ServicePROTECTIVE SERVICE NOT REQUIRED
-
International Air Transport AssociationNOT REGULATED
-
International Maritime OrganizationNOT REGULATED
-
Flashpoint TransportNo Flash Point
-
Our site states no returns allowed; however, if your order is defective or damaged, the order will be replaced with good product. In addition, we will attempt to return all your product (not only damaged product) if 3M grants the return based on various factors. Some items may be approved for return pending approval from 3M. Some but not all factors include if the item is a 3M stock item and elapsed time from receipt of product to issued return request. Note: 3M will not accept a return if the item is made to order or if the order is less than $600.00. Please double check accuracy of your orders prior to placing them. Details regarding if an item is stock or made to order can be found in the specifications tab of the item page. N = Made to order Item. S = Stock Item. We cannot guarantee any returns.
If you received a defective or damaged shipment, please email us at support@industrialgeneralstore.com explaining in detail the reason for requesting a replacement so we can contact 3M and initiate the return and new shipment.