3M™ Diamond Lapping Film 661X, 1.50 Micron Disc, 5 in x NH, 25/Inner, 250/Case
Precisely graded diamond particles coated on a polyester film. Provides a consistent, repeatable finish on extremely hard materials. Available in several grades between 0.10 and 30.0 micron.
-
Return Policy
Our site states no returns allowed; however, in addition to a few exceptions, if your order is defective or damaged, the order will be replaced with good product.
-
IndustryIB
-
Lead Time9
-
Manufacturer3M
-
SAP7010360180
-
3M ID60020005173
-
UPC00-51111-56129-4
-
Product Formal Name3M™ Diamond Lapping Film 661X, 1.50 Micron Disc, 5 in x NH, 25/Inner, 250/Case
-
Case UnitCase of 250
-
Unit of MeasureEach
-
Inner UnitInner of 25
-
Product ID661X
-
Estimated Lead Time9
-
Grit/Micron0.5 Micron, 1.5 Micron
-
Size5 in x NH
-
Diameter5 in
-
Inventory Status CodeN
-
Technical Informationhttps://multimedia.3m.com/mws/media/245184O/3mtm-diamond-lapping-film-600x-series.pdf&fn=60-5002-0032-8.pdf
-
Country of OriginUSA
-
Return PolicyNo Return
-
Width5 in
-
Box Length (in)7.7
-
Box Width (in)6.9
-
Box Height (in)4.7
- Bullets
-
Bullet 1- most widely used diamond lapping Film
- fast cut, Increased throughput
- Flatter surface and sharp edges
- uniform Finish
- Available in Discs, sheets and rolls
-
- Transportation
-
ECCN NumberEAR99
-
Harmonized Tariff Schedule Number6805301000
-
UNSPSC Code31191500
-
United States Department Of Transportation Ground US DOT, 49 CFRNOT REGULATED
-
United States Department Of Transportation Vessel US DOT, 49 CFRNOT REGULATED
-
NMFC Item001100
-
NMFC Class055.0
-
NMFC Sub00
-
Transport Protective ServicePROTECTIVE SERVICE NOT REQUIRED
-
International Air Transport AssociationNOT REGULATED
-
International Maritime OrganizationNOT REGULATED
-
Flashpoint TransportNo Flash Point
-
Our site states no returns allowed; however, if your order is defective or damaged, the order will be replaced with good product. In addition, we will attempt to return all your product (not only damaged product) if 3M grants the return based on various factors. Some items may be approved for return pending approval from 3M. Some but not all factors include if the item is a 3M stock item and elapsed time from receipt of product to issued return request. Note: 3M will not accept a return if the item is made to order or if the order is less than $600.00. Please double check accuracy of your orders prior to placing them. Details regarding if an item is stock or made to order can be found in the specifications tab of the item page. N = Made to order Item. S = Stock Item. We cannot guarantee any returns.
If you received a defective or damaged shipment, please email us at support@industrialgeneralstore.com explaining in detail the reason for requesting a replacement so we can contact 3M and initiate the return and new shipment.